The
Spring Clip has a certain service life.In order to reduce the failure rate and prolong the service life,maintenance and maintenance work must be done during the application of the Spring
Clip.
In the early stage of applying the elastic bar,we should pay attention to the use of the sleeper,such as the relaxation caused by the compression residual of the underrail plate,and should be retwisted in time.When it is found that there is an empty sleeper hanging,the height and level are not smooth or triangular pits,the track tamping should be carried out in time.If there is a small amount of height and level are not smooth and it is difficult to carry out the track tamping operation,the adjustable pad can be inserted.
In addition,the heightening pad in the spring bar shall not be placed on the lower
Rail Pad,the total thickness of the heightening pad shall not be greater than 10mm,and the number of heightening pad shall not exceed two.The gauge baffle shall be placed between the ears of the raising pad and the lower rail pad,and shall not press the raising pad or the lower rail pad.
