What are the main forms of common elastic bar clamping parts
2021-11-03
The shrapnel fastener works mainly using the bending deformation performance of the material,the processing is relatively simple,the cost is often low,but because of the hole for bolt fastening,the stress concentration is easy to occur in this part. Spring Clip USES the bending deformation of material performance at work,and USES the torsional deformation of material properties(especially the circular cross section),and generally good elasticity and basically no section weakened at the same time,so the material utilization rate is higher,on the routine,generally want to withhold pressure big,good elasticity,this article Customized Torsion Spring Clip has obvious advantages. 
The common form of Clip clamping parts mainly include:bolt installation ofωstructural form of the clip,such as the often used typeI,II,shilong bridge small resistance clip,WJ-2 type clip,etc.;Panderol type without bolt installation,such as typeIII elastic bar,DTⅵfastener with elastic bar,Guangzhou metro with PR elastic bar;There are other structural forms of sliders,two-toed sliders,middle sliders.
